lp://staging/~toykeeper/flashlight-firmware/blf-lantern
- Get this branch:
- bzr branch lp://staging/~toykeeper/flashlight-firmware/blf-lantern
Branch merges
Branch information
Recent revisions
- 389. By Selene Scriven <email address hidden>
-
the lantern middle-tint power correction factor wasn't quite right...
... so I adjusted it to make the result closer to a flat curve - 388. By Selene Scriven <email address hidden>
-
added tint ramping power correction for middle tints
(it actually needs a surprisingly large correction factor) - 387. By Selene Scriven <email address hidden>
-
moved triangle_wave into fsm-misc, because I need it for power correction in tint ramping
- 386. By Selene Scriven <email address hidden>
-
fixed bug where click-click-hold from off to strobes would also activate tint ramping when it shouldn't
- 385. By Selene Scriven <email address hidden>
-
added auto-tint modes, refactored some indicator blinks into "blip()", enabled blink at ceiling for lantern
- 384. By Selene Scriven <email address hidden>
-
made tint ramping blink at ends of ramp, made lantern default to stepped mode, lowered lantern floor, made beacon blink shorter
- 383. By Selene Scriven <email address hidden>
-
Increased default candle magnitude to better fit recent changes
(but it still uses less power than the old version, despite the larger amplitude,
because it has more of a low bias now) - 382. By Selene Scriven <email address hidden>
-
reworked candle mode a bit more, now specifies the amplitude of each wave in percent,
with a higher potential brightness but more of a low bias overall
(looks good on the lantern; haven't tried it elsewhere yet)
Branch metadata
- Branch format:
- Branch format 7
- Repository format:
- Bazaar repository format 2a (needs bzr 1.16 or later)
- Stacked on:
- lp://staging/flashlight-firmware