Cupcake Motor Controller

lp://staging/cmc

Created by Phil Frost on 2010-03-23 and last modified on 2010-09-03

Only Phil Frost can upload to this branch. If you are Phil Frost please log in for upload directions.

111. By Phil Frost on 2010-09-03: put TO220 packages flat against the board
110. By Phil Frost on 2010-08-23: start on new layout
109. By Phil Frost on 2010-08-23: fix refdes of a resistor
108. By Phil Frost on 2010-08-19: - add schottky diodes to Q*1 to avoid saturation and turn-off delay
- split turn-off resistors on mosfet gates (formerly R*4) into two separate
resistors, one for each mosfet. Hopefully this will reduce the impedance of
the turn-off circuit.
107. By Phil Frost on 2010-04-19: visual improvements to schematic
106. By Phil Frost on 2010-04-18: change capacitor to a more convenient value
105. By Phil Frost on 2010-04-18: reduce loop area in driver input signals
104. By Phil Frost on 2010-04-18: optimize gate drive layout slightly
103. By Phil Frost <indigo@rhea> on 2010-04-17: add a separate gate drive resistor to each transistor
102. By Phil Frost on 2010-04-14: minor twiddles to layout.

This branch contains Public information

Everyone can see this information.